Warning Site Requirements » The system must be unpacked and installed by an authorized Before the system is installed by an authorized Biotage service Biotage service engineer. engineer, the installation site should be prepared as follows: » Follow regional safety practices when handling and moving shipping boxes and containers, and moving the system.
If you need to move the system within the laboratory or between using a Philips #2 screwdriver. laboratories in the same building, follow the instructions below. c. Disconnect the power connector by unscrewing its If you need to ship the system, please contact Biotage 1-Point ® locking ring.
Page 5
Extrahera top ventilation to a ventilation system: pressure unit; see Figure 5. a. Connect an air duct adapter from Biotage to the outlet of the Extrahera top ventilation. b. Connect a ventilation tube between the air duct adapter and the exhaust.
S5 solvent feeder tube (left port). The gas used for the movement of the pressure head. See the gas supply requirements in the technical specification on page 6. Upgrade the Biotage Extrahera Software ® ™ Please refer to the instructions delivered with the new software.
Poor DCM/IPA/NH OH [78:20:2] Poor DCM/MeOH/NH OH [78:20:2] Poor MeOH/NH OH [95:5] Excellent Currently Not Supported Consumables The following Biotage and competitor consumables are not supported when using clog detection: » ISOLUTE PPT+ ® » ISOLUTE PLD+ ® » ISOLUTE FILTER+ Plate ®...
"Safety Requirements" on page 9. It is the responsibility of the customer to inform Biotage 1-Point Support representatives if the system has been used with There is a risk of crushing when the system is in hazardous biological, radioactive, or toxic samples and/or service mode.
» The system must be electrically grounded (earthed). Use only a power cord supplied by Biotage. The ground prong on the cord plug must not be removed and the plug should only be connected to a grounded outlet as per local and national regulations.
Page 12
Always place the solvent bottles and waste Incorrect fuses create a potential fire hazard. reservoir on the side of the system. » Use only tubing, nuts, and ferrules supplied by Biotage. » Use appropriate caps on the solvent bottles to »...
“wheelie bin” symbol on the product label, as indicated to the left. To forward a product for recycling or proper disposal, return them to Biotage Sweden AB. Before forwarding a product for recycling or disposal, it should be emptied of all liquid and cleaned from harmful residues.
General Information General Information Consumables and Accessories Only genuine Biotage accessories must be used in the system. To order consumables and accessories, see contact information on the back of this document or visit our website www.biotage.com. Manufacturer Biotage GB Limited United Kingdom for...
Need help?
Do you have a question about the Extrahera Classic and is the answer not in the manual?
Questions and answers