Installing The Radio Using Tie-Wraps - Cisco FM1200 Installation And Configuration Manual

CAUTION
Do not over-tighten the nuts. Doing so could damage the
bracket components.

4.2. Installing the radio using tie-wraps

To install the radio transceiver on a wooden or metal utility pole using the
included tie-wraps, do the following steps:
1. Decide where on the utility pole the radio must be mounted,
taking access to the radio and line-of-sight into account.
2. Place the radio against the utility pole at the chosen mounting
point (below).
3. Route the two tie-wraps through the clamp holes of the radio's
mounting lug (below).
© 2021 Cisco and/or its affiliates. All rights reserved.
Installing the radio
Page 26 of 175