Cisco FM1200 Installation And Configuration Manual page 102

• The MULTICAST dialog will be shown
102)).
Figure 40. Multicast dialog (Mesh End mode)
4. Compile the needed multicast rule. Use the following syntax rules
to create the rule:
• A multicast rule consists of two parts: a multicast group
designator and a destination address.
• Define the multicast group designator. For example, the
designator 224.1.1.0/24 indicates all multicast groups in
the range 224.1.1.1 through 224.1.1.254.
• The destination address consists of one or more Cisco
unit ID numbers, in the form 5.a.b.c. These ID numbers
belong to the physical Cisco device or devices to
which the multicast traffic must be forwarded.
• Destination-address wildcards can also be used. For
example,
5.255.255.255
wireless network.
5. Enter the multicast group designator in the
6. Enter the destination address in the
7. Click the
• The new multicast route will be shown in the Multicast
routes section.
To enable or disable multicast forwarding on a Bridge unit, do the
following steps:
1. Connect to the Bridge unit as shown in
FM1200 Volo for device configuration" (page
2. Click the -multicast link under ADVANCED SETTINGS in the
left-hand settings menu
• The Multicast dialog will be shown.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
the
represents
add button.
(Figure 41 (page
(Figure 40 (page
destination address
all Cisco units
Multicast Group field.
Destination Address field.
"Accessing the Cisco
47).
103)).
Page 102 of 175
in the