Radius Configuration - Cisco FM1200 Installation And Configuration Manual

7. Click the
• If the wireless station must dynamically assign itself a
wireless LAN IP address and netmask, select the DHCP
option.
• If a wireless LAN IP address and netmask must be
manually assigned to the wireless station, select the
STATIC option. If the STATIC option is chosen, additional
options will become available. Refer to the steps below for
more information.
If the STATIC Network Protocol option was chosen, do the following
additional steps:
1. Specify the IP address and netmask of the subnet the radio unit is
part of by entering the correct addresses in the WLAN IP address
and WLAN Netmask fields.
2. Specify the default gateway and designated name server by
entering the correct configuration data in the WLAN Default
Gateway and WLAN Name Server fields.
To access a Cisco radio transceiver through the transceiver's
wireless access point, you will need a laptop computer, tablet computer or
similar device equipped with the following:
• Wi-Fi capability.
• A current version of Mozilla Firefox or Google Chrome.
To connect wirelessly to the Cisco FM1200 Volo for configuration and
maintenance, do the following steps:
1. On your computer or other wireless interface device, use the Wi-
Fi connection dialog to connect to the radio unit using the radio
unit's WLAN SSID and WLAN passphrase.
2. Use the web browser on your computer or other wireless interface
device to access the offline Configurator interface.
3. Configure the radio unit as shown in this manual.

7.6.7. RADIUS configuration

The RADIUS window contains the controls to provide centralized
authentication, authorization, and accounting management using the
remote authentication dial-in user service (RADIUS) networking protocol.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Network Protocol drop-down menu.
IMPORTANT
If SSID broadcasting is disabled on the radio unit, you
must create a connection to the radio unit by manually
specifying the SSID and passphrase.
Page 112 of 175