Cisco FM1200 Installation And Configuration Manual page 25

Component number
05
06
07
08
09
10
To install the radio transceiver on a wooden or metal utility pole using the
Cisco multi-axis mounting bracket, do the following steps:
1. Decide where on the utility pole the unit must be mounted, taking
access to the unit and antenna line-of-sight into account.
2. Place the U-bolt (04) around the utility pole at the chosen
mounting point.
3. Place the Pole mount (01) over the two ends of the U-bolt, with
the curved end of the mount aligned with the outer curve of the
pole.
4. Place the 8.4mm flat washers (05) over the two ends of the U-
bolt.
5. Screw the M8 nuts (06) onto the two ends of the U-bolt. Do not
fully tighten the nuts at this time.
6. Insert the circular end of the Swivel rod (02) into the hollow part
of the Pole mount (01).
7. Place a 6.4mm flat washer (08) over the shaft of the M6x25mm
screw (07).
8. Push the M6x25mm screw through the securing hole of the Pole
mount, making sure that the hexagonal end of the screw seats
correctly on the casting of the Pole mount.
9. Place a second 6.4mm flat washer (08) over the threaded end of
the M6x25mm screw (07).
10. Screw the M6 nut (09) onto the threaded end of the M6x25mm
screw (07). Do not fully tighten the nut at this time.
11. Make sure that the transceiver unit faces the right way up.
12. Place the concave surface of the unit's mounting lug securely
against the cylindrical end of the Swivel rod (02).
13. Route the two tie-wraps (10) through the clamp holes of the unit's
mounting lug. Join the ends of the tie-wraps.
14. Securely fasten the transceiver unit to the Swivel rod by pulling
the ends of the tie-wraps.
15. Aim and adjust the radio correctly. You can aim the unit in the
vertical and horizontal planes.
16. Fully tighten the M6 nut and M8 nuts.
© 2021 Cisco and/or its affiliates. All rights reserved.
Description
8.4mm washer
M8 nut
M6x25 screw
6.4mm washer
M6 nut
Tie wrap
Installing the radio
Quantity
2
2
1
2
1
2
Page 25 of 175