Cisco FM1200 Installation And Configuration Manual page 137

• Upload and apply a saved configuration file to the current unit.
To download the unit's existing configuration settings to your computer, do
the following steps:
1. Click the -configuration settings link under MANAGEMENT
SETTINGS in the left-hand settings menu.
• The LOAD OR RESTORE SETTINGS dialog will be shown
(Figure 61 (page
Figure 61. Configurator GUI (LOAD OR RESTORE
SETTINGS dialog)
2. Download the unit's configuration (*.CONF) file to your computer
by clicking the Save button and following the software prompts.
To upload a saved configuration file to the Cisco unit, do the following
steps:
1. Find the configuration (*.CONF) file that must be uploaded to the
unit by clicking the Browse... button and following the software
prompts.
• The name of the configuration file to be uploaded will be
shown to the right of the Browse... button.
2. Apply the configuration settings to the unit by clicking the
Restore button.
• The configuration will be applied, and the unit will reboot.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
TIP
Saved configuration files can be copied and distributed
for use on more than one Cisco unit of the same
type, simplifying the configuration of other deployed
units.
Saved configuration files can also be used for
configuration backup. This can greatly speed up re-
deployment if a damaged unit must be replaced with a
unit of the same type.
137)).
Page 137 of 175