Table of Contents
Advertisement
Additional MIDI Requirements
Macintosh-based systems using Pro Tools
version 4.1 or earlier will also need to de-
fine an OMS device for the USD so that it
can provide MTC to other OMS-compatible
devices. See "Configuring OMS" on
page 15 for further instructions.
Software Installation
The following sections provide software in-
stallation instructions for different
Pro Tools systems and standalone opera-
tion.
The location and availability of all parame-
ters is explained in "Control Options" on
page 27.
Pro Tools MIX/MIXplus and
Pro Tools 24 Systems
Check to make sure you have already in-
stalled the most recent USD options for
your system, from your Pro Tools Installer
CD-ROM or the Digidesign Web site.
Optionally, USD Setup can be installed to
provide access to the complete set of USD
parameters, and provide remote control of
USD independent of Pro Tools.
Pro Tools III Systems
Check to make sure you have already in-
stalled the most recent Pro Tools and USD
Setup software from your Pro Tools In-
staller CD-ROM.
Optionally, USD Setup can be installed to
provide access to the complete set of USD
parameters, and for remote control of USD
independent of Pro Tools.
USD Setup
To install USD Setup:
Make sure the USD is connected to your
1
computer as described in "Standalone
Mode" on page 10.
Insert the disk containing the latest USD
2
software, or navigate to its location if you
downloaded the update.
Launch the installer and follow the on-
3
screen instructions.
Standalone
No software is required for standalone
mode except to update the USD firmware
or to use USD Setup software. See
"USD Setup" on page 13 for more informa-
tion.
Firmware updates are made available by
Digidesign to add capabilities to your USD.
These updates can be downloaded from our
Web site or obtained from your Digidesign
dealer.
Getting Started
This section includes software configura-
tion instructions applicable to
Pro Tools/USD systems.
Chapter 2: Installing the USD 13
Advertisement
Table of Contents
Need help?
Do you have a question about the Digidesign USD and is the answer not in the manual?
Questions and answers