Wali M003S Installation Manual

INSTALLATION MANUAL
Triple Monitor Desk Mount
M003S
Supplied Parts List
VESA Plate Arm
A (x3) B (x1)
C-Clamp Pole
C (x1) D (x1)
1
Measure the thickness of your mounting surface or desk
Fit clamp: 0.39"-3.3"
Grommet: 0.39"-3"
4A
Option A : Clamp Installation
1.Connect Pole D and C-Clamp Brace from the bottom using M6x12 Bolt
with Allen Key 4mm L .Tear off the protect paper and attach Anti-Skid Pads
bottom designated position of C-Clamp Brace as image shown.
D
J
I
L
75x75\100x100
Grommet Base Plate Pole Cover
F (x1) G (x1)
Support Plate Allen Key 4mm
Tool Holder
K (x1)
E (x1)
2
Press Pole Cover G
D
J and tighten 2. Connect C-Clamp to C-Clamp Brace using the bolts and tighten with Allen Key 4mm
I to the Rotate the hand knob clockwise to fasten for stability.
L
WARNING
！
www.walielectric.com
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
support@walielectric.com
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
1-844-SATTLER (18447288537)
TIPOVER WARNING
！
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
RATED
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
(7kg/15.4lbs)x2
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Top Screw Anti-skid Pad M6x12 Bolt
H (x3) I (x5) J (x3)
Allen Key 5mm Allen Key 6mm
L (x1) M (x1) N (x1)
into the top of Pole D .
G
0.39"-3.3"
M4x12 Bolt M4x16 Bolt M5x12 Bolt
M-A (x12) M-B (x12) M-C (x12)
3
Loosen the bolts on C-Clamp C using Allen Key 4mm
L
4B
Option B: Grommet Base Installation
L . 1. Loosen the screw to release the hand
knob using a screwdriver as image shown.
(Screwdriver not included)
Hand knob
M5x16 Bolt D5 Washer Spacer
M-D (x12) M-E (x12) M-F (x12)
L .
C-Clamp Brace
Clamp
2. Tear off the protect paper and attach Anti-Skid
Pads I to the bottom designated position of
Grommet Base Plate F as image shown.
F
I