Advertisement
Table of Contents
INSTALLATION MANUAL
Single Mount With Laptop Tray
M001LP
Supplied Parts List
Pole
C-Clamp
C-Clamp Brace
a (x1)
b (x1)
Grommet Base Plate
Wire Clip
Wire Clip
m (x1)
n1 (x2)
n2 (x3)
1
Option A : Clamp Installation
1. Connect Pole a and C-Clamp Brace c from the bottom using M5x14 Bolt f and
a
c
tighten with Allen Key 3mm o .
o
a
f
o
75x75\100x100
Swivel Arms
VESA Plate
c (x1)
d (x1)
e (x2)
Allen Key
Wrench
o (x1)
p (x1)
f
2. Select the preferred height according to your desk thickness. Connect C-Clamp b to C-Clamp
Brace c using M8x12 Bolt g and tighten with Allen Key 5mm o . Rotate the hand knob
c
clockwise to fasten for stability.
c
WARNING
！
www.walielectric.com
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
support@walielectric.com
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
1-844-SATTLER (18447288537)
TIPOVER WARNING
！
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
RATED
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
(10kg/22lbs)x2
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
Laptop : 17" Max
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Monitor: 27" Max
M5x14 Bolt
M8x12 Bolt
f (x3)
g (x2)
M4x12 Bolt
M4x30 Bolt
M4 Spacer
q (x8)
r (x8)
s (x8)
g
o
c
b
Hand Knob
Nut
M10 Bolt
Support Plate
h (x2)
i (x1)
j (x1)
Laptop Tray
M4x10 Bolt
M4 Nut
t (x1)
u (x4)
v (x4)
Option B : Grommet Base Installation
1. Place Pole a onto Grommet Base Plate m . Connect them from the bottom using
a
b
M5x14 Bolt
and tighten with Allen Key 3mm
f
g
o
o
M10 Washer
Spring Washer
k (x1)
l (x1)
Washer
Anti-skid Pad
w (x4)
x (x4)
m
o
.
a
m
f
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Wali M001LP
Summary of Contents for Wali M001LP
- Page 1 ● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND. RATED ● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL. (10kg/22lbs)x2 M001LP USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER. Laptop : 17” Max 75x75\100x100 SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS.
- Page 2 2a. Existing Grommet Hole Installation 2b. Self-drilled Grommet Hole Installation Put the Wire Clip n1 and Swivel Arms d through the Pole a , adjust the preferred height Mark the position of the hole on your mounting surface. Drill a 3/8"(10mm) diameter hole at the If the existing grommet hole comes with a plastic protector, remove it to ensure a flat surface before and tighten using Allen Key 6mm o .
Need help?
Do you have a question about the M001LP and is the answer not in the manual?
Questions and answers