Advertisement
Advertisement
Related Manuals for Wali WL-M002
Summary of Contents for Wali WL-M002
- Page 2 Supplied Par ts List (1) Pole-a (1) “C” Clamp-b (1) “C” Clamp Brace-c (1) Swivel Arm-d (2) VESA Plate-e (3) M5x14 Bolt-f (2) M8x12 Bolt-g (2) Nut-h (1)M10 Bolt-i (1)Support Plate-j (1)M10 Washer-k (1)Spring Washer-l (1) Grommet Base (1)Wire Clip-n1 (4)Wire Clip-n2 (1)Allen Key-o Plate-m...
- Page 3 Install the Pole to the Desktop Step 1 Option A: Desk Clamp Install 1. Install the “C”-Clamp Brace(c) to the Pole (a) using 3pcs M5x14 Bolts(f), and tighten using the Allen Key(o), see Figure 1. 2. Install the “C”-Clamp(b) to the pole assembly according to the thickness of the desktop.
- Page 4 Install the Pole to the Desktop Step 1 Option B: Grommet Base Install Self Drilled Grommet Hole Installation 1. Position the Pole(a) on the mounting surface and mark the center hole. Drill a 3/8" (10mm) diameter hole at the marked position through the mounting surface.
- Page 5 Step 3 Attach the VESA Plate to the Monitor For Monitor with Flat Back For Monitor with Curved or Recessed Back Step 4 Slide the Monitor onto the Head of Swivel Arm Slide the monitor onto the head of Install the security Nut(h). Make Swivel Arm(d) as shown in the sure the security nut is installed above diagram.
- Page 6 Fix the Tilt Angle and Adjust the Level of Monitor Step 5 Ignore this step if Fix the tilt angle monitors are level Tighten the bolt with the supplied Allen If one monitor is lower, remove the Nut(h) and turn the bolt counter-clockwise with supplied Key(o) to fix the tilt angle.