Wali M003 Installation Manual

INSTALLATION MANUAL
Triple Monitor Desk Mount
M003

Supplied Parts List

Lower Pole Upper Pole C-Clamp
a1 (x1) a2 (x1) b (x1)
Support Plate M10 Washer Spring Washer Grommet Base Plate
j (x1) k (x1) l (x1)
2
Option A : Clamp Installation Option A : Clamp Installation
1. Connect Lower Pole a and C-Clamp Brace c from the bottom using M5x14 a1 c
Bolt f and tighten with Allen Key 3mm o . f o
a1
f
o
www.walielectric.com
support@walielectric.com
1-844-SATTLER (18447288537)
(10kg/22lbs)x3
75x75\100x100
C-Clamp Brace Swivel Arm Monitor Arm VESA Plate
c (x1) d1 (x1) d2 (x1)
Wire Clip Wire Clip
m (x1) n1 (x2) n2 (x4)
2. Select the preferred height according to your desk thickness. Connect C-Clamp b to C-Clamp
Brace c using M8x12 Bolt g and tighten with Allen Key 5mm o . Rotate the hand knob c
clockwise to fasten for stability.
c
！ WARNING
If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may
cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrect
assembly or inappropriate use.
！
TIPOVER WARNING
SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:
● NEVER ALLOW CHILDREN TO CLIMB, STAND, HANG, OR PLAY ON ANY PART OF MONITOR OR STAND.
RATED
● USE TIPOVER RESTRAINT OR ANCHOR STAND TO WALL.
USE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.
SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
M5x14 Bolt M8x12 Bolt
e1 (x3) f (x3) g (x2) h (x3)
Allen Key Wrench M4x12 Bolt M4x30 Bolt
o (x1) p (x1) q (x12) r (x12)
b
g o
c
g
b
Hand Knob
Loosen the screw on the Lower Pole
1
Lower Pole
2mm o to fix the two poles. o
Pre-Assembly
Nut M10 Bolt
i (x1)
a1
M4 Spacer
s (x12)
Option B : Grommet Base Installation
1. Place Lower Pole a onto Grommet Base Plate m . Connect them from the bottom using M5x14 a1
Bolt f and tighten with Allen Key 3mm
o
f
o
a1 with Allen key 2mm o . Connect o
to Upper Pole and tighten the screw with Allen key
a1 a2
o
o
a2 a2
o
o
a1
a1
m
o .
a1
m