Related Manuals for Wali GSDM001-P
Summary of Contents for Wali GSDM001-P
- Page 1 Single Monitor Desk Mount 35" GSDM001-P 75x75/100x100 2-12kg (4.4-26. 4lbs) RATED support@walielectric.com...
- Page 3 Supplied Parts List Base Pole VESA Plate D (x1) C (x1) B (x1) A (x1) Bolt C-Clamp Cover C-clamp Brace G (x1) H (x1) E (x1) F (x1) Spring Washer Support Plate Grommet Base Plate K (x1) I (x1) L (x1) J (x1) Anti-skid Pad M6X10 Bolt...
- Page 4 Step 1 Fit clamp: 0.4”-3.3” Grommet: 0.4”-3.3“ Step 2 Option A Clamp Installation 1. Connect Pole and Base from the bottom using M6X16 Bolt and tighten with 4mm Allen Key -clamp race 2. Connect Base and C using M6x12 Bolt and tighten with 4mm Allen Key .
- Page 5 3. Select the preferred height firstly and connect C-Clamp to C-Clamp Brace using M6x10 Bolt and tighten with 4mm Allen Key 0.4’’-2.2’’ 2’’-3.3’’ 4. Rotate the hand knob clockwise to fasten for stability. Attach the Cover to the C-Clamp.
- Page 6 Option B Grommet Base Installation 1.Guide Grommet Base Plate through Bolt 2. Tear off the protective paper to attach Anti-Skid Pad to the and connect them to Base from the bottom bottom designated position of Base as image shown. using M6x12 Bolt and tighten with 4mm Allen 3b.Self-drilled Grommet Hole Installation 3a.Existing Grommet Hole Installation...
- Page 7 4. Insert the assembled pole through the desk hole, guide the Support Plate , Washer and Nut through the Bolt , rotate the Nut clockwise to fasten for stability. Step 3 Put the Arm and Wire Clip through the Pole , adjust the preferred height and tighten using 6mm Allen Key...
- Page 8 Step 4 Step 4.1 Step 4.2 Select Monitor Screws Only one screw size fits your Monitor Hand thread screws into the threaded inserts on the back of your Monitor to determine which screw (M4 or M5) to use. Step 4.2 Step 4.1 Select M4x12 Bolt or M5x12 Bolt...
- Page 9 Step 6 To properly balance the arm with monitors mounted, adjust the spring tension with 6mm Allen Key First, position and firmly hold the arm horizontally as If the arm drops, turn the adjustment screw shown. Ask for assistance should you require it. counter-clockwise until it stays in a horizontal position.
- Page 10 Step 7 Guide the cable through the cable slot.
- Page 11 Step 8 Angle Adjustments Tilt: Adjust the VESA Plate tilt using 6mm Allen Key . (Tilt: +45°/-45°) Note: Adjust to the desired angle then tighten the screws using the Allen key as shown, alternating from each screw as you tighten them. Rotate: Manually adjust rotate angle.
- Page 12 We support the technology that brings your home to life. We offer high quality products, professional customer service, and extensive technical support. If you have any questions,please contact us. support@walielectric.com 1-844-SATTLER (18447288537) www.walielectric.com...