For contractors
2.
Installation instructions
Only trained and authorised experts must install the device and make the electrical connection under full
observance of these installation instructions.
2.1
Equipment layout
1 Temperature selector
2
3 Base, back panel
4
5
6 Top, back panel
7 Electronics
8 Coding card for output selection for
the DDLE Basis 18/21/24
9
and fault indications
10 Plug-in position from the temperature
selector cable
11 Safety pressure limiter (AP 3) with reset
button
12 Mains terminal
13 Knock-out for power connection from above
14 Fixing toggle
15 Heating system
2.2
Brief description
This electronically regulated instantaneous water heater is a pressure device for the heating of cold water to
DIN 1988 that can supply one or several draw-off points.
The bare wire heating system is suitable for hard and soft water areas (for application range, see
"5.2 Application areas").
2.3
Important information
!
2.4
Instructions and regulations
as DIN VDE 0100, DIN 1988, DIN 4109, DIN 44851.
26
-
A
O
16 Flow sensor
17 Temperature selector plug "set T"
18 Type plate
19 Mounting bracket
20 Stud for mounting bracket
21 Cable grommet (power cable from above/below)
22 Twin nipple (cold water with shut off valve)
23 Flat packing
24
25 Second flow limiter, only for the DDLE Basis
18/21/24 (secured to the cold water pipe)
26 Installation and operating instructions
27 Installation template
28 Sieve
29 Flow limiter
30
31 Support panel