Installation Instructions; Composition Of The Unit - AEG MP 6 Operating And Installation Instructions

For the Professional
2.

Installation instructions

2.1

Composition of the unit

1 Terminal strip
2 Safety temperature limiter with reset button
3 Rear panel
4 Cold-water connection G 1/2"
5 Hot-water connection G 1/2"
6 Unit cover
7 Heating system
8 Electronics for power control
9 Cable entry for electric supply connection with rubber grommet
2.2 Important note
All the information in these Installation and Operating Instructions must be followed carefully.
These Instructions provide important details regarding safety, operation, installation, and
maintenance of the unit.
2.3 Technical data
Type
Design
Rated overpressure
Capacity
Weight
Protection class as per VDE
Protection mode as per VDE
Test mark
Water connection
Electrical connection
Rated power at
Over-sink installation for
supplying one or two draw-off points
Switch-on volumes
Switch-on flow pressure
Pressure loss
Suitable for cold water
1)
External thread
Suitable
Table 2
12
MPa
l
kg
1)
220 V kW
MPa
l/min
MP 6 MP 8
Unvented
1.0
0.5
2.4 2.4
1
IP 24
See unit rating plate
G 1/2 G 1/2
1/N/PE ~ 220 V
6.0 8.0
≥ 2.6 ≥ 3.0
0.025 0.03
2.6 3.0