Kernau KFRT 12152.1 W Instruction Booklet page 26

INSTALLING AND OPERATING YOUR FRIDGE
Before starting to use your fridge freezer, you should pay attention to the following points:
• The operating voltage for your fridge is 220-240 V at 50Hz.
• The plug must be accessible after installation.
• Your fridge freezer may have a smell when it is operated for the first time. This is
normal and the smell will fade away when your fridge freezer starts to cool.
• Before connecting your fridge freezer, ensure that the information on the data plate
(voltage and connected load) matches that of the mains electricity supply. If in doubt,
consult a qualified electrician.
• Insert the plug into a socket with an efficient ground connection. If the socket has
no ground contact or the plug does not match, we recommend that you consult
a qualified electrician for assistance.
• The appliance must be connected with a properly installed fused socket. Power
supply (AC) and voltage at the operating point must match with the details on the
name plate of the appliance (name plate is located on the inside left of the appliance).
• We do not accept responsibility for any damages that occur due to ungrounded usage.
• Place your fridge where it will not be exposed to direct sunlight.
• Your fridge should never be used outdoors or exposed to rain.
• Your appliance should be at least 50 cm away from stoves, gas ovens and heater
cores, and at least 5 cm away from electrical ovens.
• When your fridge is placed next to a deep freezer, there should be at least 2 cm
between them to prevent humidity forming on the outer surface.
• Do not place heavy items on the appliance.
• Clean the appliance thoroughly, especially the interior, before use (see Cleaning and
Maintenance).
• The installation procedure into the kitchen unit is given in the installation manual.
This product is intended to be used in proper kitchen units only.
• Before using your fridge freezer, wipe all parts with a solution of warm water and
a teaspoon of sodium bicarbonate, then rinse with clean water and dry. Place all
parts in the fridge after cleaning.
• Install the plastic distance guide (the part with black vanes at the rear) by turning it
90° (as shown in the figure) to prevent the condenser from touching the wall.
• The refrigerator should be placed against a wall with a free space not exceeding
75 mm.
BEFORE USING YOUR FRIDGE FREEZER
• When using your fridge freezer for the first time, or after transportation, keep it in
an upright position for at least 3 hours before plugging into the mains. This allows
efficient operation and prevents damage to the compressor.
• Your fridge freezer may have a smell when it is operated for the first time. This is
normal and the smell will fade away when your fridge starts to cool.
EN 26