Initial Commissioning With The Help Of The Installation Wizard - RADEMACHER RolloTron Comfort DuoFern Translation Of The Original Operating And Assembly Manual

i

13. Initial commissioning with the help of the installation wizard

An installation wizard is available in order to help you
configure the RolloTron Comfort DuoFern quickly and
easily. The wizard automatically guides you through the
configuration process for initial commissioning or after
a software reset (see page 74).
Quitting the installation wizard.
Pressing the [ M ] button for 2 seconds causes the instal-
lation wizard to be cancelled prematurely.
Readiness for operation
The RolloTron Comfort DuoFern is ready for use as soon
as the installation wizard has finished.
In addition, you can individually customise your settings
and make changes at any time from the main menu and
the system settings menu.
Additional information about configuring the
end points
The end points must be configured in order for the roller
shutters to stop at the desired upper and lower positions.
It is imperative that both end points are configured, oth-
erwise malfunctions may occur.
28
i
If the RolloTron Comfort DuoFern is operated without an
end point setting, the drive will continue to run for as long
as one of the two control buttons is actuated.
◆ The automatic functions remain blocked until the end
point setting is configured.
◆ Please ensure that the belt is not excessively slack
when reaching the lower end point.
ATTENTION!
Setting the wrong upper end point may lead to over-
load or damage the RolloTron Comfort DuoFern or the
drive.
◆ Do not set the upper end point right up to the limit
stop.
◆ Release the button promptly and never allow it to
extend beyond the respective end point.
i
After a period of time it may be necessary to reconfig-
ure the end points as the belt may elongate during the
process of operation due to stretching.
EN