Co Alarm Value Setting - Lutron Electronics GCO-2008 Operation Manual

5-3 Setting the CO alarm value
When the lower display show " AL " :
1)Press the " Enter Button " ( 3-4, Fig. 1 ) once, the upper
display will show " CO alarm value " with PPM unit,
use the "
▲
Fig. 1 ) to select the " CO alarm value ".
2)After setting the CO alarm value, press the
" Enter Button " ( 3-4, Fig. 1 ) will save the setting value
with default.
* If before press the " Enter Button ", just press
the " ESC Button " ( 3-3, Fig. 1 ) will escape the
Advanced Setting procedures without saving the
alarm value into the circuit memory.
Button " ( 3-5, Fig. 1 ) or "
9
Button " ( 3-6,
▼