Shortcuts; Preparing Environment And Transferring Environment To Programmer - Softlog Systems ICP Series User Manual

Distributor of Microchip Technology: Excellent Integrated System Limited
Datasheet of TPG100001 - PROGRAMMER ICSP ICP2 SOFTLOG
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
ICP Family User's Manual

11 Shortcuts

Save
Open...
Program
Verify
Blank Check
Read
Programming Only
Menu
Close Window
Exit
12 Preparing Environment and Transferring Environment to
Programmer

Run "Environment/Environment Wizard" and follow the Wizard

Select programmer and press "Next"

select GANG channels and press "Next"
ICP2-GANG only:
ICP2-Portable only: select environment number and press "Next"

Select Device
From the "Device" list select a device to be programmed and press "Next"

Set Voltages and press "Next"

Load (open) a HEX file.
NOTE: The programmer software is able to read ID information, data memory (EEPROM) contents and
configuration bits from the HEX file

Save Environment
- Press on "..." button
- Type in environment name, 16 characters max
- Press "Save"
- Press "Next"

Transfer Environment to Programmer
- Press on "Transfer Environment" button, select your environment and press "Open"
- Wait until environment is transferred to all channels
- Press "Next"

Switch to Standalone Mode
- Press on "Standalone Mode" button
- Press "Finish"

Your system is ready for standalone programming
Ctrl-S
Ctrl-O
F5
F6
F7
F8
F9
F10
Ctrl-F4
Alt-F4