Nexcom ICES 675 User Manual page 38

Chapter 3: BIOS Setup
Serial Port Console Redirection
This section is used to configure the serial port that will be used for console
redirection.
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Advanced
COM0
[Disabled]
Console Redirection
► Console Redirection Settings
COM1
Console Redirection [Disabled]
► Console Redirection Settings
COM2(Pci Bus0,Dev0,Func0) (Disabled)
Console Redirection Port Is Disabled
Legacy Console Redirection
Legacy Console Redirection Settings
►
Serial Port for Out-of-Band Management /
Windows Emergency Management Services (EMS)
Console Redirection [Disabled]
► Console Redirection Settings
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Console Redirection
Enables or disables console redirection.
Copyright © 2019 NEXCOM International Co., Ltd. All Rights Reserved.
USB Configuration
This section is used to configure the USB.
Console Redirection Enable or
Disable.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Legacy USB Support
Enable Enables Legacy USB.
Auto
Disable Keeps USB devices available only for EFI applications.
XHCI Hand-off
This is a workaround for OSs that does not support XHCI hand-off. The
XHCI ownership change should be claimed by the XHCI driver respectively.
USB Mass Storage Driver Support
Enables or disables USB mass storage driver support.
25
Aptio Setup Utility - Copyright (C) 2019 American Megatrends, Inc.
Advanced
USB Configuration
21
USB Module Version
USB Controllers:
1 XHCI
USB Devices:
1 Keyboard
Legacy USB Support [Enabled]
[Disabled]
XHCI Hand-off
USB Mass Storage Driver Support [Enabled]
USB hardware delays and time-outs:
USB transfer time-out [20 sec]
Device reset time-out [20 sec]
Device power-up delay [Auto]
Version 2.20.1271. Copyright (C) 2019 American Megatrends, Inc.
Disables support for Legacy when no USB devices are connected.
Enables Legacy USB support.
AUTO option disables legacy
support if no USB devices are
connected. DISABLE option will
keep USB devices available
only for EFI applications.
→←: Select Screen
↑↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
ICES 675 User Manual