Raider RD-SGC07 User Manual page 15

15
Dip the viscosity test cup completely into the coating material.
Hold the test cup up and measure the time in seconds until the liquid empties out.
Note: This time is called "Runout Time in Seconds".
2. Start-up.
Before connecting to the mains supply, be sure that the supply voltage is identical with the
value given on the rating plate.
Mounting air hose. Insert the air hose tightly in connections on the machine and the spray gun.
The connections can be positioned as desired.
3. Unscrew the container from the spray gun.
4. Aligning suction tube .The container contents are to be sprayed out almost completely.
When spraying horizontal surfaces, turn suction tube forward (A). When spraying objects
overhead, turn suction tube back (B).
5. Set the container on a sheet of paper, pour in the prepared coating material and screw the
container tightly onto the spray gun.
6. Put the machine down only on a level, clean surface. Otherwise the machine could suck in
dust, etc.
7. Hang the machine on your shoulder with the carrying belt.
8. Take the spray gun out of the spray gun holder and point it at the target object.
9. Push the ON / OFF switch on the machine.
IV. Spray Technique.
The spray result depends heavily on the smoothness and cleanliness of the surface to be
sprayed. Therefore the surface should be carefully prepared and kept free of dust. Cover all
surfaces not to be sprayed. Cover screw threads or similar parts of the target object. It is
advisable to test the spray gun on cardboard or a similar surface to find the correct setting.
Important: Begin spraying outside of the target area and avoid interruptions inside the target
area. An even movement of the spray gun results in an even surface quality.
V. Taking Out of Operation and Cleaning.
1. Turn the machine off. Activate the trigger guard so that the coating material in the spray gun
flows back into the container.
2. Unscrew the container. Empty any remaining coating material back into the material tin.