Table of Contents
Advertisement
5 Maintenance
5.1
Maintenance schedule
The following sections describe the maintenance work that is required for optimal and fault-free
operation of the device.
Check wearing parts such as seals, nozzles and needles at regular intervals. The level of wear
depends on the abrasiveness of the spray fluid used. Escaping air and spray fluid as well as the
deterioration of the spray pattern are signs that parts are worn. In case of questions about mainte-
nance work and intervals, contact the manufacturer; see contact data on the last page.
Interval
Maintenance work
After each use
Clean hand held spray gun (
hand held spray gun" on page 12)
When required
Change fluid and air nozzle (
the air and fluid nozzles" on page 14)
Change fluid needle (
fluid needle" on page 15)
Tighten needle seals (
seals" on page 17)
Change needle seals (
seals" on page 17)
5.2
Maintenance work
Clean the device before all maintenance work (
gun" on page 12).
5.2.1 Clean hand held spray gun
WARNING!
Danger of injury due to improper cleaning!
–
Observe the safety datasheets of the detergent manufacturer.
–
Do not immerse the hand held spray gun entirely in detergent.
GB–12
Operating instructions
Ä Chapter 5.2.1 „Clean
Ä Chapter 5.2.2 „Changing
Ä Chapter 5.2.3 „Changing the
Ä Chapter 5.2.4 „Changing
Ä Chapter 5.2.4 „Changing
Ä Chapter 5.2.1 „Clean hand held spray
T-Dok-009-GB-Rev.0
Personnel
Qualified personnel
Qualified personnel
Qualified personnel
Qualified personnel
Qualified personnel
mail@krautzberger.com, www.krautzberger.com
Advertisement
Table of Contents
