Advertisement
Maintenance and care
Regular lubrication is a prerequisite for the proper functioning of your pneumatic tool and a
long service life. The following lubrication options are available:
◦ Using a mist lubricator: A complete maintenance unit includes a mist lubricator and is at-
tached to the compressor (not included).
◦ Using a line oiler:
A line lubricator is installed in the immediate vicinity of the tool (approx. 50 cm dis-
▪
tance), which supplies the tool sufficiently with oil.
If the pneumatic tool has been out of operation for several days, you must add 5–
▪
10 drops of special tool oil to the compressed air connection before switching it on.
◦ By hand: If your system has neither a maintenance unit nor a line lubricator, you must add
3–5 drops of special tool oil to the compressed air connection before each commissioning
of your rod grinder.
Store your air tool only in dry, frost-proof rooms.
Technical data
Maximum operating pressure
(applies to all compressed air
devices in the set)
Tool
Max. release torque (Nm)
Max. tightening torque (Nm)
Max. rotation speed (rpm)
Vibration under load (
Square socket (inch)
Sound pressure level (dB (A))
Air consumption (ℓ/s)
Weight (kg)
Tool
Stroke rate (strokes/min)
Air consumption (ℓ/min)
Compressed air connection (inch)
Weight (kg)
Tool
Max. release torque (Nm)
Max. work area
Sound pressure level (dB (A))
Vibration under load (
Max. rotation speed (rpm)
Air consumption (ℓ/min)
Weight (kg)
Tool
Max. rotations speed (rpm)
Air consumption (ℓ/min)
Compressed air connection (inch)
Weight (kg)
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Impact wrench
311
approx. 250
7000
m
/
)
< 2.5
s²
½
89
approx. 6
approx. 2
Chisel hammer
4500
approx. 200
¼
approx. 1.5
Ratchet screwdriver
61
M8
89
m
/
)
< 14,7
s²
150
approx. 200
approx. 1.2
Rod grinder
22000
approx. 200
¼
approx. 0.6
Item 61870
6 bar
Page 9
02
2021-1
Advertisement
