Advertisement
Assembly and commissioning in general
Before start-up
Seal the supplied plug nipple with Teflon tape and then screw it into the compressed air con-
nection.
Operate the compressed air unit only with an oiler.
Pressure reducer must be present on the compressor.
Install a water separator (filter) before the oiler.
The maximum operating pressure of your air tool is 6 bar. If you set your pressure minimum
higher than 6 bar, your air tool may be overloaded.
During longer breaks in operation, we recommend cleaning and lubricating the air tool thor-
oughly.
When the unit is put back into operation, add some compressed air oil to the connection of the
compressed air unit, let the unit run for a short time, then operate it with a compressed air lub -
ricator. Some units are equipped with an infinitely variable regulation for speed and impact
force (e. g. impact wrench, drill left/right barrel, chisel hammer set, random orbit sander, etc.).
Tool: impact wrench
Figure
№ Name
A
Square for nut holder
B
Switch lever (left/right
rotation)
C
Trigger lever
Intended use
The impact wrench is suitable for tightening and loosening screw connections using com-
pressed air.
Do not use impact wrenches for purposes other than their intended purpose.
Secure pneumatic tools against children.
Only to go to work rested and concentrated.
Compressed air connection only via a quick-release coupling
Working pressure adjustment must be carried out via a pressure reducer.
Do not use oxygen or flammable gases as energy source.
Before any maintenance, adjustment or cleaning work, disconnect the unit from the com-
pressed air source.
Only use original spare parts.
Never run unloaded at full idle speed.
Wear the necessary protective clothing when working with the impact wrench.
Start-up
Screw the supplied plug-in nipple into the compressed air connection (E) and seal it with Te-
flon tape.
Insert the required plug-in attachment onto the square (A). Set the correct direction of rotation
on the reversing lever (B):
◦ Push backwards ("REVERSE") = counter-clockwise = loosen screw
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
№ Name
D
Air controller or torque
controller
E
Compressed air connec-
tion
Item 61870
Page 5
02
2021-1
Advertisement
