Advertisement
Intended use
The ratchet wrench is a handy, pneumatic tool for manual use.
It is used to generate a rotary motion within a limited working area for loosening or tightening
screw connections.
Start-up
Screw the plug nipple into the reducing nipple. Use a ring spanner or open-end wrench. At-
tention: Seal the thread with Teflon tape!
Attach the required socket wrench set to the actuator. Connect the air hose with quick coup-
ling to the plug nipple. Place the socket wrench insert on the nut or screw to be loosened or
tightened. Set the desired direction of rotation on the changeover lever, actuate the trigger
lever.
Maintenance and care
Regular lubrication is a prerequisite for the proper functioning of your pneumatic tool and a
long service life. The following lubrication options are available:
◦ Using a mist lubricator: A complete maintenance unit includes a mist lubricator and is at-
tached to the compressor (not included).
◦ Using a line oiler:
A line lubricator is installed in the immediate vicinity of the tool (approx. 50 cm dis-
▪
tance), which supplies the tool sufficiently with oil.
If the pneumatic tool has been out of operation for several days, you must add 5–
▪
10 drops of special tool oil to the compressed air connection before switching it on.
◦ By hand: If your system has neither a maintenance unit nor a line lubricator, you must add
3–5 drops of special tool oil to the compressed air connection before each commissioning
of your ratchet screwdriver.
Store your air tool only in dry, frost-proof rooms.
Tool: Rod grinder
ATTENTION:
yourself or other persons. Connect the unit to the air supply hose.
Intended use
The compressed air-powered device is suitable for smoothing surfaces or removing coatings
from surfaces.
Not suitable for industrial processing of parts.
Operating instructions
Before connecting the compressed air hose to the unit, make sure that the operating lever is
NOT pressed!
Always secure the workpiece to be handled before handling it with the pneumatic tool. Never
hold the workpiece with one hand while operating the tool with the other!
Never exert too much pressure on the workpiece, this could result in a recoil with unforesee -
able consequences (injuries)!
All attachment replacement, adjustment and maintenance work may only be carried out with a
separate compressed air hose.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Never point the rotating end of the tool towards
Item 61870
Page 8
02
2021-1
Advertisement
