CONFIGURATION OPTIONS
3.1.3
Setting Up Your Password
3.1.4
DDFR Configuration Techniques
3.1.4.1 Single DDFR Unit
3.1.4.2 Multiple DDFR Units
48
•
Watchdogs
•
SyncClock
•
Clear Data
•
Firmware Update
•
Admin.
The default password for your new DDFR unit is "password".
To change this,
From the main menu, select Security > Change Password
Follow the instructions on the screen.
You can configure the (relay) settings for a single DDFR unit using either
• a direct connection - connected via an Ethernet cable to the configuring computer
on the bench or desktop, or
• an indirect connection - the DDFR connected to an existing system, and the
configuring computer connected to this system via a (GE MultiLink) switch.
The latter is the more convenient approach.
You can configure the (relay) settings for each DDFR directly, as discussed above, then
connect all the units to the existing system, or you can connect all the units to the existing
system and configure the settings of each of them "indirectly" with the configuring
computer connected to this system via a (GE MultiLink) switch.
CHAPTER 3: DDFR CONFIGURATION
DISTRIBUTED DIGITAL FAULT RECORDER – INSTRUCTION MANUAL