Lightspeed Topcat LSRCNG User Manual page 14

Setting Up the Flexmike
Once the Flexmike is charged, follow these steps for use.
1. Remove the Flexmike from the charger and put it on by connecting the
magnetic clasps behind your neck. Adjust the lanyard so that the top of
the Flexmike aligns with the collarbone.
2. The Flexmike will automatically power on and mute when it is removed
from the charger.
3. The microphone volume on the Flexmike is set at the factory to the
midpoint. It is adjusted by the up/ down buttons on the side of the mic.
4. While speaking in a normal voice, fine tune the microphone volume.
Proper volume level should be as follows:
• Your voice should be clearly heard by another person on the other side
of the room.
• You should barely be able to hear your own voice.
• There should not be any audio "feedback" or squealing outside of 2-3
feet (if there is, turn the volume down slightly).
REMEMBER: This equipment supplements the user's voice so they are able
to speak in a conversational tone. Having the volume set too high will result in
feedback and listener fatigue.
• Once initial volume level is set, walk around the room and listen for overall
audio quality.
• If further fine tuning is required, you may need to adjust the Tone Control
inside the speaker case.
14
ALIGN WITH
COLLARBONE
TALK / MUTE LIGHT TALK
MUTE
FLEXMIKE
VOLUME
CONTROL