Table of Contents
Advertisement
Installing the Device
2.4 Connecting the Failsafe Alarm Relay
To mount the device to a panel, do the following:
1.
2.
2.4
Connecting the Failsafe Alarm Relay
The failsafe relay can be configured to latch based on alarm conditions. The NO
(Normally Open) contact is closed when the unit is powered and there are no active
alarms. If the device is not powered or if an active alarm is configured, the relay
opens the NO contact and closes the NC (Normally Closed) contact.
Note
Control of the failsafe relay output is configurable through RUGGEDCOM
RSG2300PF . One common application for this relay is to signal an alarm if a power
failure occurs. For more information, refer to the RUGGEDCOM ROS Configuration
Manual for the RUGGEDCOM RSG2300PF.
The following shows the proper relay connections.
12
Place the device against the panel and align the adapters with the mounting
holes.
1
1
Screw
1
Panel/DIN Rail Adapter
2
Figure 2.3
Panel Mounting
Install the supplied screws to secure the adapters to the panel.
RUGGEDCOM RSG2300PF
Installation Manual, 04/2021, C79000-G8976-1348-09
2
Advertisement
Table of Contents
