Table of Contents
Advertisement
EN
Setting cool only or heat only modes
It is possible to deactivate the heating or the cooling modes
following a simple procedure.
Keep the A key on the touch-screen display pressed for
5 seconds until HC (heating and cooling) appears on the
display.
Press the A key for 1 second to switch to the CO (cooling
only) mode.
Brightness regulation
The display brightness sensor can be disabled (leaving the
maximum brightness at all times) by pressing and holding
Touch-screen display key lock
The key lock is activated by keeping the Timer
the touch-screen display pressed for three
The user cannot perform any actions.
The stand-by symbol flashes every second.
To deactivate the lock, keep the Timer symbol on the touch
Hotel function
Press and hold the air exchange key (
seconds to enable the function ("En" displayed); the
dehumidification and Auto functions are disabled (leaving
8
Soloclim Vertical - Utilisation
Press the A key again to switch back to HO (heating only)
mode.
Wait for 3 seconds without touching anything to memorise
the setting and return to normal operations.
the night button (
"En" (enabled) will appear on the display.
screen pressed for three seconds once again.
symbol on
The lock remains active also for the next operations
seconds.
performed via remote control and in the event of a power
failure.
active only ventilation, heating and cooling) and the
) for 10
settable set range is reduced from 22 to 28 in cooling mode
and from 16 to 24 in heating mode).
) for 10 seconds. "ds" (disabled) or
Advertisement
Table of Contents
