Table of Contents
Advertisement
5.10 Resetting the Wizard DXS - Digital to factory default
For situations where the IP address or the password has been forgotten, or the Wizard DXS - Digital is being reinstalled, it is
possible to reset the unit to its original factory settings. This erases all configuration such as hosts, users and passwords, and
restores the default network address.
5.10.1.1 To perform a factory reset:
1 Disconnect power and all other cables from the Wizard DXS - Digital unit.
2 Set Configuration Switch 2 to the ON (up) position.
3 Apply power to the unit (either from the power supply or via both USB cables).
4 Within five seconds set Switch 2 to the OFF (down) position.
Note: If the orange indicator illuminates while switch 2 is still in the ON position then it is too late to place it in the OFF
position. Power down and try again.
If the factory reset is successful, the orange indicator will flash once after fifteen seconds.
After the factory reset is complete, the unit will reboot and you can connect a VNC viewer to it using the default IP address:
192.168.1.42 to check that the configuration has been reset.
877-877-2269 | blackbox.com
Chapter 5: Operation
Page 35
Advertisement
Table of Contents
