Table of Contents
Advertisement
3.2.3 Power supply connection
The Wizard DXS - Digital provides flexibility in the way that it is powered in order to suit your installation requirements. Each
Wizard DXS - Digital can be powered:
• Via both USB connections from the host computer, or
• From the supplied autosensing power adaptor.
3.2.3.1 Power supply issues and options
If you intend to derive power from the host computer then both USB connections must be made to the host computer. The
Wizard DXS - Digital will share its requirements between the two ports and will automatically refuse to operate if only one
connection is made.
If you want to disable virtual media by omitting its USB cable, then you will need to use the supplied power adaptor. On the side
panel of the Wizard DXS - Digital, use switch 1 to determine how power should be derived:
SW1
OFF
Derive Wizard DXS - Digital power from either the USB connections or the
supplied power adaptor.
ON
Derive Wizard DXS - Digital power only from the supplied power adaptor.
Note: SW2 is used to reset the Wizard DXS - Digital back to its
is also used during
firmware
3.2.3.2 To connect the power adaptor
1 Connect the low voltage output connector from the power supply adaptor to the power socket on the end panel of the
Wizard DXS - Digital.
2 Connect the IEC connector of the supplied country-specific power lead to the socket of the power supply.
3 Connect the power lead to a nearby mains supply socket.
upgrades.
Low voltage
output connector
from the supplied
power adaptor
Figure 3-7. Connecting the power adaptor
877-877-2269 | blackbox.com
factory defaults
and
Chapter 3: Installation
Figure 3-6. Power derivation switch
Page 15
Advertisement
Table of Contents
