Advertisement
Speed settings (dependant on model)
The rotation speed of the sanding disc can be adjusted according to the conditions and requirements
to the quality of sanding. The drywall sander is equipped with a variable speed control. The speed is
set by turning the control knob. The operating button is marked from "1" to "6," 1 being the slowest set-
ting (approx. 1500 rpm) and "6" the fastest (approx. 3500 rpm). Use the higher settings for a fast re-
moval. Use the lower range of settings for more precise result.
Starting and stopping the drywall sander
Ensure that the voltage of the electrical circuit used matches up with the one on the type plate of the
sander and that the electrical switch is switched off. Connect the sander with the electrical circuit. The
drywall sander is equipped with a rocker switch. The upper option is to turn the machine off and the
lower option is to turn the machine on. To start the drywall sander: Select the lower option on and to
stop the drywall sander select the upper option off.
Drywall sanding
The drywall sander has a unique hinged sanding head and a sanding sheet which adjusts the
work surface.
This way the operator is able to sand the top, centre and the bottom of a wall or ceiling joint.
When sanding a tall wall or ceiling, please use a ladder to reach the higher areas.
The sanding pad is able to adjust the sanding height autonomously when encountering a un-
even wall.
Attention:
Wear a respiratory mask that is qualified for dust.
Switch the drywall sander on.
Position the drywall sander gently against the surface needing to be processed.
Use light pressure to press the sanding disc of the drywall sander against the work surface.
Move the drywall sander in an overlapping pattern to sand the work surface down.
Keep the sander in constant movement whilst holding contact to any surface. Use an even
swinging movement. Stopping the sander (on the surface) or moving it irregularly can lead to
undesired and uneven results of the work surface.
Attention:
Do not touch sharp edges with the rotating sanding pad. Touching protruding items (nails,
screws, distribution boxes, etc.) can damage the sanding disc.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61857
Page 9
02
2021-1
Advertisement
