Maintenance And Care - Flex XFE 15 125 18.0-EC Operating Instructions Manual

XFE 15 125 18.0-EC / XFE 15 150 18.0-EC / XCE 8 125 18.0-EC
Charging process
CAUTION!
Insert only original batteries in the supplied
charger.
Insert the charger mains plug. The display

backlighting lights up green for 2 seconds
and then goes out again. OK is displayed.
Insert the battery fully into the charger

until it clicks into place.
– The time remaining in the charging
process (until the battery is fully
charged) and a graphic representation
of the state of charge are shown
alternately in the display.
– The display backlighting lights up
orange when the battery is charged
less than 80%.
– When the battery charge reaches 80%
the display lights up green and OK is
indicated.
The battery is fully charged when the

display
The green backlighting goes out after
a short time.
Remove the battery from the charger.

appears.
Pull out the mains plug.

NOTE
If the display flashes after the battery is
inserted in the charger, there is a fault in the
battery or in the charger.
Display flashes slowly.
Backlighting orange.
The battery is too hot or too cold. The charging
process starts when the battery reaches the
charging temperature (0°C...55°C).
Display flashes rapidly.
Backlighting red.
Remove the battery from the charger and
insert again. If the same display persists, the
battery is faulty. Replace the battery or have
it checked at an authorised repair shop.
If this error message is displayed again with
a different battery, this indicates that there
is a fault in the charger. Have the charger
checked at an authorised repair shop.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
Clean the power tool and grille in front of

the vent slots regularly. Frequency of
cleaning is dependent on the material
and duration of use.
Regularly blow out the housing interior

and motor with dry compressed air.
23