Instructions For Use - Flex XFE 15 125 18.0-EC Operating Instructions Manual

Instructions for use

WARNING!
Remove the battery before carrying out any
work on the power tool.
Before switching on the polisher
Unpack the polisher and check that there
are no missing or damaged parts.
NOTE
The batteries are not fully charged on
delivery. Prior to initial operation, charge
the batteries fully. Refer to the charger
operating manual.
Inserting/replacing the battery
Press the charged battery into the power

tool until it clicks into place.
To remove, press the release button (1.)

and pull out the battery (2.).
CAUTION!
When the device is not in use, protect the
battery contacts. Loose metal parts may
short-circuit the contacts; explosion and fire
hazard!
20
XFE 15 125 18.0-EC / XFE 15 150 18.0-EC / XCE 8 125 18.0-EC
Battery state of charge
Press the button to check the state of

charge at the state of charge indicator
LEDs.
he indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
Attaching/changing the tool
Remove the battery.

Firmly press polishing tool, centred on

the eye, onto the Velcro pad. Use
undamaged polishing tools only.
Insert the battery.

Switch on the polisher (without

engaging it) and run the polisher for
approx. 30 seconds. Check for
imbalances and vibrations.
Switch off the polisher.

Attaching the tools
CAUTION!
Attach the tools in the centre of the tool
holder. Imbalances may damage the power
tool. The work result may be impaired.