General Power Tool Safety Warnings; Work Area Safety - Parkside PFSA 20-Li A1 Translation Of The Original Instructions

High-speed battery charger PLG 20 A1*
INPUT
Rated voltage
Rated power
consumption
Fuse (internal)
OUTPUT
Rated voltage
Rated current
Charging time
Protection class
* BATTERY AND CHARGER ARE NOT INCLUDED
Noise and vibration data
Noise measurement value determined in accordance
with EN 60745 . The A-rated noise level of the
power tool is typically as follows:
Sound pressure level
Uncertainty
Sound power level
Uncertainty
Wear ear muffs!
Total vibration value of the handle a
Uncertainty
Symbols on the appliance
Always wear safety goggles .
Always wear a mask .
NOTE
► The vibration emission value given in these
instructions has been measured in accord-
ance with a standardised test procedure and
can be used for comparison of the power
tool with another tool .
► The specified vibration emission value can
also be used to make an initial exposure
estimate .
PFSA 20-Li A1
230–240 V ∼, 50 Hz (AC)
65 W
3 .15 A
T3.15A
21 .5 V (DC)
2 .4 A
approx . 60 min
II / (double insulation)
L = 72 dB (A)
pA
K = 3 dB
L = 83 dB (A)
WA
K = 3 dB
< 2 .5 m/s
h
K = 1 .5 m/s
WARNING!
► The vibration emission value may differ from
the stated value during actual use of the
power tool, depending on of the manner in
which the power tool is being used .
► Try to keep the vibration loads as low as
possible . Measures to reduce the vibration
load are, e .g . wearing gloves and limiting the
working time . Wherein all states of operation
must be included (e .g . times when the power
tool is switched off and times where the power
tool is switched on but running without load) .
General power tool
safety warnings
WARNING!
► Read all safety warnings and all instructions .
Failure to follow the warnings and instructions
may result in electric shock, fire and/or
serious injury .
Save all warnings and instructions for future
2
reference.
2
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-
operated (cordless) power tool .

1 . Work area safety

a) Keep work area clean and well lit.
Cluttered or dark areas invite accidents .
b) Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes .
c) Keep children and bystanders away while
operating a power tool. Distractions can
cause you to lose control .
GB │ IE │ NI │ 3 ■