Commend C-G3-TEL Product Manual page 19

G8-TEL / G3-TEL
Individual messages
For the several call types (conversation, call and emergency call) and for each station to or from which
a call is set up, additional information can be put out. For the so-called individual messages, the follow-
ing applies:
 Individual messages are put out at the corresponding point of time (e.g. at start up of a conversation)
at the telephone (see also "Examples for the call procedure" on page
 Individual messages can be configured for the
 Individual messages are composed out of single WAV files (e.g. "Conversation to...", "one", "zero"
or "five"; each word under quotation marks is a single WAV file;
on page 17).
NOTE: Hexadecimal numbers
The announcement of the call number for hexadecimal numbers is not possible. That is if hexadecimal
input numbers are use for input messages, for example, these hexadecimal digits will not be
announced.
Configuration CCT 800
 Interfaces > TEL > folder telephone interface > Telephone functions
 Click on Individual messages. A dialogue appears.
 Right-click on the blank area and select the option "Add message" for each desired individual mes-
sage.
 In the field Call number, enter the call number of the Intercom station to or from which the call is
initiated. If the message shall be valid for all Intercom stations, enter "*".
NOTE: Wildcards
In the field Call number, wildcards can also be entered
wildcards" on page
 In the drop-down list Call Type, select the event or the type of the respective call (e.g. "Conversation
started" or "Call 1 (Normal call)").
 Activate the checkbox Call no. announcement activated if the call number of the calling Intercom
station shall be announced after the respective message (e.g. "two, one, five").
 In the drop-down list Retries, select if the message shall be played once, twice or is repeated until
"*" is pressed at the telephone or the respective call request is taken over with "#". Options: "only
1 time", "2 times" or "until finished".
 In the field Message number, enter the corresponding number (resp. ID) of the speech storage mes-
sage to be put out
 Click on Accept.
Dialogue "Individual messages" in CCT 800
2.0/0817
23).
(see "Standard speech messages" on page
"Auto-dialler mode" as well as for
see "Standard speech messages"
(see also "Define a range of numbers via
17).
Auto-dialler mode
12).
"PABX mode".
19