Maintenance - Vacmaster VK1630SWC Manual

GB
IMPORTANT! When vacuuming large quantities of liquids, do not immerse the nozzle completely;
leave a gap at the tip of the nozzle to allow air inflow. The machine is fitted with a float valve that
stops the suction action when the container reaches its maximum capacity. You will notice an
increase in motor noise. When this happens, turn off the machine, disconnect from power supply,
and drain the liquid. To continue vacuuming, replace the drainage cap.
WARNING:
CARRYING OUT ANY MAINTENANCE.
1) Keep all safety devices, air vents and the motor housing free of dirt and dust. Use a soft, dry
brush to clean the equipment regularly.
2) Clear all dirt or debris from the collection tank after each use. Allow to dry before replacing the
power head. Do not use cleaning agents or solvents; these may damage the appliance.
3) Check the hose, attachments, and power cord to verify that they have not been damaged or
any debris is trapped and blocking airflow.
1. Cleaning Cartridge Filter
Remove the filter and clean by gently tapping or brushing off dirt. For optimal performance it is
recommended to replace the old filter with a new filter regularly.
2. Cleaning Foam Filter & Nylon Pre-filter
Remove the foam filter or nylon pre-filter. Use a mild soap and water solution to wash and rinse
with clean water (Fig. 11). Allow filter to air dry before installing and using again.
3. Cleaning & Replacing Exhaust Filter
1) Unlock the exhaust filter door by lifting the locking tab upwards to release. Pull the door out
(Fig. 12).
2) Remove the exhaust filter from the vacuum and clean by gently tapping or brushing off dirt. For
optimal performance it is recommended to replace the old filter with a new filter regularly
(Fig. 13).
3) Install the cleaned or new filter. Then insert the filter door tabs into the upper slots and lock the
filter door into place.

MAINTENANCE

REMOVE THE POWER CORD FROM THE POWER SUPPLY BEFORE
12