Power On (Auto Water Fill / Automatic Preheat); Preheat The Steamer; High Limit Reset - Cleveland SteamChef 22CET3.1 Operator's Manual

G. Power ON (Auto Water Fill/Automatic Preheat)
1. Open the water supply valves to the steamer.
2. Set the Timed/Manual switch to timed (dial timer steamers) or
set the Selector Switch to OFF (ON/OFF control steamers).
3. Turn ON power to the steamer by turning the drain valve lever
clockwise (down) to close the drain (see Figure 3-8). The
power ON indicator lights and the water reservoir fills.
4. Close the door. When the water reservoir is filled to the
minimum operating level the heater turns on and heats the
water to the standby cooking temperature.
5. Time to Standby Temperature:
Dial timer steamers: When the "SureCook" indicator light
•
goes OFF, the steamer is preheated.
ON/OFF control steamers take 10 to 15 minutes to reach
•
the standby heating temperature.
H. Preheat the Steamer
Preheat to help ensure productivity and consistency.
•
BEFORE PREHEATING: Inspect and clean the compartment. After preheating, the compartment
•
will be too hot to inspect and clean safely.
To preheat the SteamChef Steamer:
•
1. Close the steamer door and turn the steamer ON 15 minutes before cooking.
2. The Steamer will heat to the standby temperature.
I.

High Limit Reset

This steamer has a high limit lockout to protect the unit from overheating.
•
If the high limit lockout temperature is reached:
•
1. The RESET light will turn ON
2. A buzzer will sound continuously
3. The heater will shut OFF
4. The steamer must be reset before cooking can continue
To reset the high limit:
•
1. Turn OFF power to the steamer with the ON/OFF lever.
2. Wait 15 minutes for the steamer to cool
3. Make sure the water probes are clean (Chapters 3 and 6).
4. Refill with water and restart according to the Power ON instructions (Chapter 3).
5. If the problem repeats, see the Operators Troubleshooting Guide (Chapter 8).
8
ON
OFF
Figure 3-8
ON/OFF Lever
(Shown in ON Position)