Roller Service (Roller Shaft With Circlip) - Toro Greensmaster Flex 21 Service Manual

Roller Service (Roller Shaft with Circlip)

6
5
4
1. Wiehle roller
2. Smooth roller
Seal Removal
1. Using a 1/4 inch thick, 3" X 3" square piece of steel,
make a seal removal tool as shown in Figure 30.
2. Slide seal removal tool over roller shaft.
3. Using the tool as a template, locate, mark and drill
two 7/64 inch (.109 inch diameter) holes in outer face of
seal.
4. Screw two No. 8 (.164 inch diameter) by 3/4 inch long
self–tapping screws into outer face of seal.
5. Install two 1/4–20 by 1 inch long cap screws into seal
removal tool.
6. Alternately tighten cap screws to pull seal out of roller
assembly. Discard removed seals.
NOTE: Seals will be destroyed when servicing the roll-
ers. Do not re–use seals that have been removed.
Cutting Unit (Rev. C)
1
2
3. Roller shaft
4. Roller bearing
3
Figure 29
Bearing Removal
NOTE: It is recommended to replace bearings at both
ends of the roller after bearing failure.
1. Remove both seals from roller (See Seal Removal).
Remove both spiral retaining rings from roller shaft:
catch ring removal notch with pick and pull ring from
shaft.
NOTE: Roller bearings are pressed into rollers and slip
fit on roller shafts.
2. Loosely secure roller assembly in bench vise and
lightly tap one end of roller shaft until shaft and bearing
are free from roller cavity.
3. Remove second bearing from roller cavity by sup-
porting roller assembly and tapping on roller shaft.
4. Clean bearing cavity in roller and remove any rust
with crocus cloth.
5. Inspect bearings, shaft, retaining rings and roller for
damage. Replace components as needed.
Page 7 – 20
4
5
5. Spiral retaining ring
6. Roller seal
Greensmaster Flex 21
6