Applying The Arm Cuff; How To Take Accurate Measurements; Measurement; After Measurement - AND UA-704 Instruction Manual

Applying the Arm Cuff

1. Wrap the cuff around the upper arm,
about 1-2 cm above the inside of the
elbow, as shown.
Place the cuff directly against the
skin, as clothing may cause a faint
pulse and result in a measurement
error.
2. Constriction of the upper arm, caused
by tightly rolling up a shirtsleeve, may
prevent accurate readings.
3. Confirm that the index
within the proper fit range.

How to Take Accurate Measurements

For the most accurate blood pressure measurement:
Sit comfortably on a chair. Rest your arm on the table. Do not cross
your legs. Keep your feet flat on the floor and straighten your back.
Relax for about five to ten minutes before measurement.
Place the center of the cuff at the same level as your heart.
Remain still and keep quiet during measurement.
Do not measure immediately after physical exercise or a bath. Rest for
twenty or thirty minutes before taking the measurement.
Try to measure your blood pressure at the same time every day.

Measurement

During measurement, it is normal for the cuff to feel very tight.
Measure your blood pressure according to the section "Measurement".

After Measurement

Press the exhaust valve to exhaust air from the cuff.
Press the
START
Remove the cuff and record your data.
Note: The device has an automatic power shut-off function, which turns off
the power automatically one minute after measurement.
Allow at least three minutes between measurements on the same
person.
Using the Monitor
points
button to turn off the power.
English 8
Do not roll up shirtsleeve tightly
Cuff
1-2 cm
Artery position mark
Secure the fabric
fastener firmly
Index and Proper fit range
Air hose