Install A Processor And Heat Sink - Lenovo HR650X V2 User Manual

b. Hold the processor by its edges; then, lift the processor from the heat sink and carrier.
c. Without putting the processor down, wipe the thermal grease from the top of the processor
with an alcohol cleaning pad; then, place the processor on a static protective surface with the
processor-contact side up.
Step 2. Separate the processor carrier from the heat sink.
Figure 67. Separating a processor carrier the from heat sink
Note: The processor carrier will be discarded and replaced with a new one.
a. Release the retaining clips from the heat sink.
b. Lift the carrier from the heat sink.
c. Wipe the thermal grease from the bottom of the heat sink with an alcohol cleaning pad.
After you finish
If you are instructed to return the defective component, please package the part to prevent any shipping
damage. Reuse the packaging the new part arrived in and follow all packaging instructions.

Install a processor and heat sink

This task has instructions for installing an assembled processor and heat sink, known as a processor-heat-
sink module (PHM). This task requires a Torx T30 driver. This procedure must be executed by a trained
technician.
About this task
Attention:
• Read "Installation Guidelines" on page 25 to ensure that you work safely.
• Power off the server and disconnect all power cords for this task.
• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
• Each processor socket must always contain a cover or a PHM. When removing or installing a PHM,
protect empty processor sockets with a cover.
.
Chapter 4 Hardware replacement procedures
103