Lenovo HR650X V2 User Manual page 47

• Prevent exposure to static electricity, which might lead to system halt and loss of data, by keeping static-
sensitive components in their static-protective packages until installation, and handling these devices with
an electrostatic-discharge wrist strap or other grounding system.
Procedure
Step 1. Touch the static-protective package that contains the new M.2 adapter and M.2 drive to any
unpainted surface on the outside of the server. Then, take the new M.2 adapter and M.2 drive out
of the package and place them on a static-protective surface.
Note: Your M.2 adapter might look different from the following illustrations, but the installation
method is the same.
Step 2. Adjust the retainer on the M.2 adapter to accommodate the particular size of the M.2 drive you wish
to install. See "Adjust the retainer on the M.2 adapter" on page 38.
Step 3. Locate the connector on the M.2 adapter.
Note: Some M.2 adapters support two identical M.2 drives. Install the M.2 drive in slot 0 first.
Figure 17. M.2 drive slot
1
Slot 0
2
Slot 1
.
Chapter 4 Hardware replacement procedures
39