AKCP SPX+ Introduction Manual page 78

SPX+ Introduction Manual - updated until firmware 4997
SNMP Get, sensor logic evaluation and ping commands among others are all possible from the
virtual sensors. An example use of this could be to use the SPX+ as a probe manager. If you had a
SPX+ and multiple sensorProbe devices they could all be monitored, mapped and alerted via the
SPX+. You can perform SNMP Get commands on a server to monitor memory or CPU load, or you
can ping network enabled devices and be alerted if they go offline.
Please note:
The Virtual Sensor Ping cannot ping an IP address on the VPN network.
We'll explain more about the Virtual Sensors and how to configure them in the Notifications manual.
- 78 -