AKCP SPX+ Introduction Manual page 55

SNMPv3
The SNMPv3 options can be found by scrolling down on the SNMP page.
This feature requires a separate license. You can read more details about the licensing below in this
manual.
Below we'll give a quick description of each setting:
Level
No Authentication
Authentication Only MD5 or SHA
Auth&Privacy
Basically if you select No Authentication then the setup will be the same as with SNMP v1 and v2c
versions: authentication is only checked by unencrypted username.
Authentication Only will provide password protection but no encryption.
Authentication&Privacy provides encrypted username and password protection.
Authentication
Username
MD5 or SHA
SPX+ Introduction Manual - updated until firmware 4997
Encryption Description
No Match Username (same as SNMP v1/v2c)
No Auth Based on Algorithms (check password)
Yes - DES Auth Algorithms and Encryption
- 55 -