Setting Up The Unit's Ip Address - AKCP SPX+ Introduction Manual

SPX+ Introduction Manual - updated until firmware 4997

Setting up the unit's IP address

Very Important Note: The unit's ship with the passwords enabled. The default log in for the web
interface is Username: admin Password: public
Every unit is shipped with the default IP address of 192.168.0.100
First we will go through the process of changing this IP address to fit your own network configuration.
Note: In some cases your computer might not be able to connect to this default IP address. In this
situation you either need to:
a) add this IP your computers routing table or
b) add a secondary IP address to the LAN card to allow access to the unit.
See below how to setup these.
Ensure the following items are available to you before starting:
- RJ45 CAT5 crossover cable with RJ45 male connection
- A PC with Ethernet card or LAN socket, logged in with Administrator rights
1) Connect the unit via the Ethernet port of the unit to your computers LAN or Ethernet port with a
CAT5 crossover cable.
2) Open a web browser and type the default IP address, hit enter.
You'll be presented by the Summary page.
Go to the System/Network page to change the network settings (see below in this manual).
Once you have assigned the new IP address use the "ping" command to test the unit's reply.
- 15 -