Advertisement

www.AKCP.com
SPX+ BEB Expansion Manual
Copyright © 2018, AKCP

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SPX+ and is the answer not in the manual?

Questions and answers

Summary of Contents for AKCP SPX+

  • Page 1 SPX+ BEB Expansion Manual Copyright © 2018, AKCP...
  • Page 2 SPX+ BEB Expansion Manual Table of Contents BEB Introduction ....................... 3 BEB installation and configuration information ..............4 SPX+ Web UI configuration....................6 - 2 -...
  • Page 3 SPX+ BEB Expansion Manual Introduction The BEB or (Basic Expansion Bus) units provide a simple yet cost effective way to increase the amount of sensors and dry contacts using multiple BEB (slave units) to the single “Master” SPX+ remote unit and its single IP address. These provide a lower cost solution for adding sensors or dry contacts and works on a short distance only.
  • Page 4 SPX+ BEB Expansion Manual Installation The BEB units are easy to install, and ready to mount with in the 19” racks, or cabinets. As shown in the diagram above, you can mount each BEB in the 1U configuration and daisy chain them using the BEB connection ports.
  • Page 5 10 meters to ensure good communications and power is received on all BEB units. Support for the AKCP Swing Handle Cabinet Locks There are no limitations on the RFID Swing Handle Locks as the SPX+ units can handle 16, so you can connect them to BEB units as well as the main unit.
  • Page 6 Now the sensors and notifications and dry contacts can be configured normally. Please refer to the SPX+ Manuals for detailed configuration of the sensors (the available options match with the Web UI options). All AKCP type sensors are supported on the BEB slave units, including the AKCP Swing Handle Locks.
  • Page 7 SPX+ BEB Expansion Manual Please contact support@akcp.com if you have any further technical questions or problems Thanks for Choosing AKCP! - 7 -...

Table of Contents