Table of Contents
Advertisement
Note!
63
5
Press the DISP button again to select sub-category 1.2.F, and use
the ARROW buttons to increase or decrease the parameter value
until the value corresponds with the parameter for the new Sensitive
element. Confirm the entry by pressing the ACK/ENT button.
6
Repeat step 5 for sub-category 1.3.S, 1.4.u, 1.5.L and 1.6.t.
7
Press the SET button again to return to main category A1, and then
press the DISP button to go to A2 main category.
8
Press the SET button, and enter values for 2.1.o and 2.3.h as
described above.
9
While still in A2 main category, enter values for 2.5.y (Year), 2.6.N
(Month and Day), 2.7.t (Hour and Minute) and 2.8.d (total days of
operation. This value should be reset after installation).
All time parameters should preferably be in CET (Central European Time)
or, if not possible, in local time.
10
Press the SET button again to return to main category A2, and then
press the DISP button until main category A7 is displayed.
11
Exit the sub-category by pressing the SET button, and then exit the
Extension main category by pressing and holding the SET and
ACK/ENT buttons simultaneously for appr. 3 seconds.
For more information about the Extension menu, see
SETTINGS
, page 68 onwards.
Setting the Latitude input source
When the system is configured as described in
system
on page 62 onwards, the latitude input source can be changed as
described below:
1
Press the DISP button until the display shows latitude value.
2
Press the SET button once, and the upper line in the display starts
flashing.
3
Use the ARROW buttons to select Gyro or GPS as the latitude input
source, and confirm the entry by pressing the ACK/ENT button.
Simrad GC80/85 Compact MK2 Gyro Compass
ADVANCED
Configuring the Gyro
988-12718-003
Advertisement
Table of Contents
