HandHeld ALGIZ RT8 Manual page 13

NOTICE:
The SAR limit of Europe is 2.0 W/kg. Device types ALGIZ RT8 has also been tested against this SAR limit. The
highest SAR value reported under this standard during product certification for use on the body is 0.0843W/kg
This device was tested for typical body - worn operations with the back of the handset kept 0 cm from the body.
To maintain compliance with RF exposure requirements, use accessories that maintain a 0 cm separation
distance between the user's body and the back of the handset. The use of belt clips, holsters and similar
accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy
these requirements may not comply with RF exposure requirements and should be avoided.
Working Temperature: -20°C ~ +55°C
Storage Temperature: -40°C ~ +70°C
Charging mode need to operate indoors, please pay attention to the environment temperature should be 0℃ ~
+45℃
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED
BATTERIES ACCORDING TO THE INSTRUCTIONS
Hereby, [Handheld Group AB] declares that the radio equipment type.
[ALGIZ RT8] is in compliance with Directive 2014 / 53 /EU.
The full text of the EU declaration of conformity is available at the following internet address:
www,handheldgroup.com
This device complies with Part 22 & 24 and Part 27 of the FCC Rules.
SAR INFORMATION
The SAR limit of FCC and ISED is 1.6 W/kg averaged over one gram of tissue. Device types ALGIZ RT8 (FCC
ID:YY3-118208 and IC: 11695A-118208 ) has also been tested against this SAR limit. The highest SAR value
reported under this standard during product certification for use on the body is 0.939W/kg. This device was
tested for typical body -worn operations with the back of the handset kept 0 cm from the body. To maintain
compliance with FCC and ISED RF exposure requirements, use accessories that maintain a 0 cm separation
distance between the user's body and the back of the handset. The use of belt clips, holsters and similar
accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy
these requirements may not comply with FCC and ISED RF exposure requirements and should be avoided.
13
Ver 1.0