Connecting Cables
Basic Connections
Complete these basic connections for the standard configuration as shown below:
•
+24VDC
•
Net I/O
•
Ultrasound Input (J1)
•
Grounding
•
Ultrasonic Probe Outputs
Details about the various system connectors and their pin assignments are covered in
the next section.
1. Wire the +24VDC connector to an external +24VDC power supply. Attach the
connector to the MPC-E +24VDC input, matching the power source "+", "-", and
ground connections.
2. Connect the Ethernet cable from the generator to the P1 Net I/O input connector.
3. Connect the ultrasonic generator J1 output to the MPC-E ultrasound input J1.
4. Connect the included ground wire from the PE grounding stud to a protective earth
ground.
5. Connect ultrasound coax cables from the MPC-E probe outputs to the ultrasonic
probes.
iQ Series, MPC-E User's Manual
Figure 3-1 MPC-E Rear Panel View
10