Windows; Power Window Controls - Jeep GRAND CHEROKEE L 2021 Owner's Manual

Your vehicle may be equipped with a 15W 3A Qi
wireless charging pad located inside of the storage
area below the climate controls. This charging pad
is designed to wirelessly charge your Qi enabled
mobile phone. Qi is a standard that allows wireless
charging of your mobile phone.
Your mobile phone must be designed for Qi
wireless charging. If the phone is not equipped
with Qi wireless charging functionality, an
aftermarket sleeve or a specialized back plate can
be purchased from your mobile phone provider or
a local electronics retailer. Please see your
phone's Owner's Manual for further information.
The wireless charging pad is equipped with an
anti-slip mat to hold your mobile phone in place,
and an LED indicator light.
LED Indicator Status:
No Light: Charging pad is idle or searching for a

device.
Blue Light: Device is detected and is charging.

Red Light/Flashing: Internal error or foreign

object is detected.
NOTE:
All vehicle doors must be closed for the wireless

charging pad to operate.
Using a phone case may interfere with wireless

charging.
If the phone moves on the pad causing the red

light to illuminate, the phone will have to be
picked up and placed back on the charging pad
to resume charging.
CAUTION!
The key fob should not be placed on the
charging pad or within 6 inches (15 cm) of it.
Doing so can cause excessive heat buildup and
damage to the fob. Placing the fob in close
proximity of the charging pad blocks the fob from
being detected by the vehicle and prevents the
vehicle from starting.

WINDOWS

P W C
OWER INDOW ONTROLS
The power window controls, located on the driver's
door trim panel, operate the window movement for
all four power windows.
There is a single switch on the front passenger
door and rear passenger doors which operate the
windows for only that door.
GETTING TO KNOW YOUR VEHICLE
Driver's Door Power Window Switches
NOTE:
The power window switches remain active for up

to 10 minutes after the ignition has been placed
in the OFF position. Opening a vehicle front door
will cancel this feature.
The window controls will operate only when

the vehicle's ignition is placed in the ON/RUN
position.
The power windows may be operated from

outside of the vehicle by using the key fob. For
more information, see page 17.
Ú
77
2