National Instruments PXIe-5450 Safety, Environmental, And Regulatory Information

SAFETY, ENVIRONMENTAL, AND REGULATORY INFORMATION
PXIe-5450
PXIe, 145 MHz Bandwidth, 16-Bit I/Q PXI Waveform Generator
Read this document and the documents listed in the additional resources section about installation, configuration, and operation of this equipment before you
install, configure, operate, or maintain this product. Users are required to familiarize themselves with installation and wiring instructions in addition to
requirements of all applicable codes, laws, and standards.
Regulatory Icons
•
—Notice—Take precautions to avoid data loss, loss of signal integrity, degradation of performance, or damage to the model.
•
—Caution—Take precautions to avoid injury. Consult the model documentation for cautionary statements when you see this icon printed on the
model. Cautionary statements are localized into French for C-UL certification.
•
—Warning—Take precautions to avoid electrical shock.

Safety

Caution Observe all instructions and cautions in the user documentation. Using the model in a manner not specified can damage the model and
compromise the built-in safety protection. Return damaged models to NI for repair.
Attention Suivez toutes les instructions et respectez toutes les mises en garde de la documentation utilisateur. L'utilisation d'un modèle de toute autre
façon que celle spécifiée risque de l'endommager et de compromettre la protection de sécurité intégrée. Renvoyez les modèles endommagés à NI pour
réparation.

Safety Voltage and Frequency

Notice The protection provided by the PXIe-5450 can be impaired if it is used in a manner not described in the user documentation.
Voltage
Frequency

EMC Guidelines

This product was tested and complies with the regulatory requirements and limits for electromagnetic compatibility (EMC) stated in the product specifications.
These requirements and limits provide reasonable protection against harmful interference when the product is operated in the intended operational
electromagnetic environment.
This product is intended for use in industrial locations. However, harmful interference may occur in some installations, when the product is connected to a
peripheral device or test object, or if the product is used in residential or commercial areas. To minimize interference with radio and television reception and
prevent unacceptable performance degradation, install and use this product in strict accordance with the instructions in the product documentation.
Furthermore, any changes or modifications to the product not expressly approved by National Instruments could void your authority to operate it under your
local regulatory rules.
Notice The outputs of this sensitive test and measurement product are not protected for electromagnetic interference for functional reasons. As a
result, this product may experience reduced accuracy or other temporary performance degradation when cables are attached in an environment with
electromagnetic interference present.

Physical Characteristics

Weight (unloaded)
Dimensions

Maintenance

Clean the hardware with a soft, nonmetallic brush. Make sure that the hardware is completely dry and free from contaminants before returning it to service.
±1 V
145 MHz
476 g (17 oz)
3U, two-slot, PXI Express module, 21.6 cm × 4.0 cm × 13.0 cm
(8.5 in. × 1.6 in. × 5.1 in.)